SDS0500I Command : verb jobname,command,operands
SDS0501I Command : Refer to jobname SYSOUT files for response
SCI is acknowledging receipt of the command. It is being routed to a command processor, if one exists for this command. The issuance and placement of response messages are the responsibility of the command processor.
If no response messages are found, the command was probably misspelled. Correct the spelling of the command and retry.
SDS0501E Command unrecognized: identifier
A MODIFY command was directed to the VFTP agent, but the command identifier is not recognized by VFTP. The command is not processed. Check the command syntax and try again.
SDS0502I Command processing complete; full response in output.
The operator has directed a console MODIFY command to the agent.The command has been received and will be processed. This message is for information only.
SDS0503I WTO logging stopped at max_lines lines.
A command response has exceeded the number of lines specified on the MAX=max_lines command parameter. The response will be truncated. No action is necessary. To see all the response lines, it may be necessary to increase the MAX value on the command.
SDS0504E MAX parameter value exceeds 65535. Ignored
This message is issued when an SCI command contains a MAX= parameter with a numeric value larger than 65,535 or an asterisk MAX=*. The default MAX=100 is used, and the command is processed with any other parameters that were specified.
SDS0505E Command processing abended.
An abend has been trapped while processing a command. A dump will be taken; gather the dump and logs. If the condition persists, contact SDS Technical Support.