These messages are issued by the SCI loader. They are issued strictly as WTO (Write To Operator) messages. As such they will appear on the system console and the JESMSGLG of the job but not in any SYSOUT file. Each describes an error condition which prevents successful launch of the software.
The most probable causes of failure are:
missing modules
inadequate authorization
insufficient region size
SDS0000E Module xxxxxxxx not found.
SDS0001E Required APF authorization not found.
SDS0002I ABEND=YES honored at end-of-job.
An intentional ABEND was generated, probably to call attention to a problem. For example, the VFTP client may set ABEND=YES if it cannot contact the agent.
SDS0003E Failed to build trace table.
SDS0004E Failed to setup recovery environment.
SDS0005E SSMSPACE or SSMCLASS failed for SCI.
SDS0006E X-tended Debugging Control failed.
SDS0007E SDS Storage Manager failed.
SDS0008E SDS Common Infrastructure failed.
SDS0009E Shutdown because of error conditions.
SDS0011W VFTP client is not APF authorized. FTP is processed by the IBM client.
The VFTP client transferred control to the IBM client because the runtime library is not APF authorized. To run the client under VFTP, APF authorize the VFTP runtime library. If running FTP under TSO (batch or interactive) and using the VFTP client exit, you must add FTP to the AUTHCMD and AUTHPGM NAMES section of your IKJTSOxx member of SYS1.PARMLIB.