SDS0400E XDCINFO : Unable to load XDC software.
This message indicates that SCI was unable to load XDC software when servicing an XDC command. XDC software is used by SDS developers for debugging.
SDS0401I XDCINFO : XDC support is now ON.
XDC software has been enabled, but not yet disabled.
SDS0402I XDCINFO : XDC support is now OFF.
XDC software has either not been enabled or has been disabled.
SDS0410E TRACE : Unable to locate trace table.
Trace table entries cannot be displayed because the trace table cannot be found.
SDS0411I TRCINFO : Traces have been resumed.
The trace table is unlocked and its contents are subject to change without notice.
SDS0412I TRCINFO : Traces have been suspended.
The trace table is locked. Its contents are not subject to change.
SDS0413I TRACE : Beginning of trace table.
SDS0414I TRACE : $P1 @ $P2 $P3=$P4 $P5=$P6 NOTE=”$P7″.
SDS0417I TRACE : End of trace table.
These messages provide detailed information about the trace table entries selected by the TRACE command.
SDS0418E TRACE : TASK PGM NOTE must not all be wildcards.
The TRACE command was rejected because the filters were not sufficiently specific.
SDS0419I TRACE : Nothing met your TASK|PGM|NOTE filters.
The TRACE command was processed but no trace table entries met the filtering criteria.
SDS0420E SNAP : Unable to locate specified object.
The SNAP command failed because the specified object could not be found. This can also occur when the syntax of the SNAP command is incorrect causing a misinterpretation of the operands by the SNAP command processor.
SDS0430I ‘$P1’.
This message is used by STROBE to print its report.
SDS0431I Strobe sampling is starting.
SDS0432I Strobe sampling is complete. Report follows:
SDS0433I Strobe report is complete.
SDS0434E Strobe is already running.
A STROBE command has been rejected for the reason stated.
SDS0435E Strobe is terminating for want of storage.
Strobe is running and has determined that a storage threshold has been reached. Strobe will terminate rather than threaten the health of the agent. It may be necessary to increase the agent’s REGION size to run Strobe.